![]() ![]() Choose a combination that is easy for you to remember but difficult for others to guess.Ĭ) Press the “Program” button again. The LED light on the keypad will illuminate or flash.ī) Enter a four-digit PIN of your choice using the keypad. Once you’ve located it, follow these steps:Ī) Begin by pressing the “Program” button on the keypad. You will need to find the keypad on the exterior of your garage, usually mounted near the door. Now, it’s time to set up your personal access code on the keypad. The LED light on the motor unit will flash or blink, indicating that the garage door opener is ready to receive new codes. To enter the programming mode, press and release the “Learn” button on the motor unit. This action clears all previously stored codes from the garage door opener. To do this, press and hold the “Learn” button until the LED light on the motor unit turns off. If you have previously programmed the keypad or want to start fresh, it’s recommended to clear any existing codes before programming new ones. Once you’ve located the button, ensure it is accessible and easy to reach. The location of this button may vary depending on the specific model, but it is typically found on the back or side of the motor unit. The first step is to locate the “Learn” button on your Genie garage door opener motor unit. Programming the keypad allows you to open and close the garage door without a physical key or remote control. How to Program Genie Keypad Garage Door Opener
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |